Dry wiping could scratch the finish.Įxtreme heat and cold are to be avoided. Wash the vehicle in the shade - never in the sun.ĭo not “dry wipe” the vehicle - always use clean water. Wash the vehicle by hand with cool water and a very mild car wash solution. Stiff brushes or sponges could mar the finish and damage the surface. We recommend that you follow these simple precautions in the first few months of new paint finish’s life:ĭo not use a commercial car wash. The stone chip should be filled with paint.ĭamaged panels or seriously rusted areas that have not been touched in will require thorough sanding and filling before priming and topcoating. Stone chipped panels should be touched in as soon as possible to prevent corrosion creep. The lance should not be used closer than 18” from the surface. Hot pressure cleaners can also be used, but care should be exercised to keep the temperature below 50☌. Solutions for automated washers are highly concentrated and dilution ratios of 500:1 are not uncommon and clean water should be used as a final rinse. It should be removed at the earliest practicable opportunity.Īutomated vehicle washers can be used but care must be exercised with the detergent solutions used. In order to keep the paintwork in good condition, general road film and atmospheric pollution must not be allowed to accrue. We use the best in colour-matching tools to precisely match factory standards. Light reflects differently on curved and flat surfaces causing the appearance of a colour shift. Slight adjustments can be made during application creating a lighter or darker colour, or causing the metallics or mica elements to lay down differently. The body was painted on a production line at the factory, while other parts, such as the bumper and trim were painted at another location using a different application method. A longer rate gives a flake pigment additional time to 'float' and can darken the face of the colour. For example, the evaporation rate for solven varies over metal or plastic. Well, here are some of the causes of colour variations:Ī colour can vary depending on the substrate it is painted. Ever wondered why the factory original colour of the bumper and trim pieces may not match the rest of the vehicle?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |